ActiveLab™
MULTI-MATERIAL 3D PRINTER
Visual start guide

04. Pumping Mode

                                                                         

In order to set the correct pumping mode for materials, navigate to the Materials section of the settings tab.

The user will be able to select between LOCAL and REMOTE for local pumping and remote pumping, respectively. The selected pumping mode will highlight in blue.

Purge material does not show this option, since it is limited to remote pumping. 

mceclip0.png

 

If the new cartridge to be installed is not completely full, double click the green bar to enter a percent estimate of material, then click OK.

Always be conservative when estimating percentages, since running out of materials can result in printing errors.

 

The bar will turn red when a cartridge has less than 15% material left, and the user will be prompted to change it.

 

 

                                                                         

Have more questions? Submit a request