The user is able to jog the X, Y and Z axis at the speeds of 5.00 mm/s, 50.00 mm/s, and 150.00 mm/s, as well as the A, B, C, and D material axis at speeds of 5 uL/s, 25 uL/s and 50 uL/s at the nest (otherwise known as priming).
Ensure that the nozzle clears the height of the print bed prior to jogging across. Prior to jogging the material axis, bring the printhead to nest and check to see that impeller is spinning.
Once the axis and speed is selected, jogging can be done continuously by pressing the + or - buttons during the move, or incrementally by setting the job step and pressing the + or - button once to execute the move.
The STOP button can be pressed during any incremental move to stop the motion instantly.
Special commands are available in the manual tab:
The user may also individually purge individual material inputs by pressing the following buttons:
- Purge A
- Purge B
- Purge C
- Purge D